ET48 2.0 Build (Bag N-P)
Follow along as we give some insight on how to build the new ET48 2.0 kit with both photos and videos from Tyler Hooks. This article focuses on Bags N-P.
The ET48 2.0 kits are starting to ship so here is a little guide to building your own.
Bag N
Bag N is the complete electronics installation, just forewarning, depending on the servo you use you might need a servo extension for your servo. Other than that the wiring is pretty straight forward.
![](https://blog.teknorc.com/wp-content/uploads/2021/05/IMG_1474-683x512.jpg)
Use loctite to attach the motor to the mount, and the mount to the center diff assembly.
![](https://blog.teknorc.com/wp-content/uploads/2021/05/IMG_1475-683x512.jpg)
I always put my battery leads towards the rear of the car to prevent hard impacts right on the internal connections.
![](https://blog.teknorc.com/wp-content/uploads/2021/05/IMG_1476-683x512.jpg)
Bag O-P:
I didn’t really show any of the steps for this because it is all super straight forward, make sure there is a millimeter gap between the rod ends on the steering link, and I personally use an aluminum servo horn but that is pretty much it. Button up the build and go rip!
![](https://blog.teknorc.com/wp-content/uploads/2021/05/IMG_1526-822x380.png)
![](https://blog.teknorc.com/wp-content/uploads/2021/05/IMG_1480-1-683x512.jpg)
Thank you for watching and reading, we hope you enjoyed the build and love your new ET48 2.0!